GB
83
Rear connection to a masonry chimney
Mark out the centre for making a hole in the wall to the flue. Check
that the connection height in the chimney breast corresponds to the
height of the connection pipe from the stove.
Make a 180 mm diameter hole.
Then cement in the wall connector with
fireproof mortar (not supplied).
Let the mortar dry before the stove is
connected to the chimney.
Tap out the knock out in the
rear panel using a hammer and
cut the heat deflector on the
rear side of the back panel.
Mount the back plate and
install the connection pipe on
the connection. Make sure that
the gasket does not work loose
from its position. Installation
of the surrounds for the
respective models is described
later on in these installation
instructions.
Seal between the connection
pipe and the connector in the
wall using fire rope. If further
sealing material is required,
heat-resistant sealant may be
used.
Connection to chimney
