Handlink WG-500P 24Roam, User Manual

Page: 88 / 91

WG-500P Hotspot in a Printer
4 Appendix A Signal Connection Arrangements
RJ-45 Ethernet Port
The WG-500P 24Roam RJ-45 Ethernet port can connect to any networking devices
that use a standard LAN interface, such as a Hub/Switch Hub or Router. Use
unshielded twisted-pair (UTP) or shield twisted-pair (STP) cable to connect the
networking device to the RJ-45 Ethernet port.
Depending on the type of connection, 10Mbps or 100Mbps, use the following
Ethernet cable, as prescribed.
10Mbps: Use EIA/TIA-568-100-Category 3, 4 or 5 cables. 100Mbps: Use
EIA/TIA-568-100-Category 5 cable.
Figure RJ-45 Connector and Cable Pins
Note: To prevent loss of signal, make sure that the length of any twisted-pair
connection does not exceed 100 meters.
87