Pro-Stitcher Lite for the HQ Simply Sixteen
Installation Instructions | 31
Attaching the transition box to the bracket
1. Remove the bracket knob and washer. Hold the
bolt into the bracket and place the transition
box bracket, washer and knob onto the bolt.
Hand tighten the knob.
2. Insert the end of the zip tie from front to back
through the bracket and transition box and then
back through the box and bracket to the front.
3. Put the end through the locking head
of the zip tie. Pull the zip tie tight and
trim off the end with scissors or wire
cutters.
Attaching the tablet to the HQ Simply
Sixteen machine
1. Loosen the knob on the back of the
tablet mount and raise the top of the
mount.
2. Tilt the tablet out slightly at the top and snap it
down into the lower mount tabs, then tilt back.
3. Lower the top of the mount down onto the
tablet until the mount top tabs snap onto the
tablet and tighten the knob firmly by hand.
4. Ensure the tablet is held securely in the mount,
if not repeat step 3 and press the top of the
mount down onto the tablet before tightening
the knob.
5. Plug in the power cable (see Parts List, item J)
from the transition box to the tablet.
NOTE: Be sure it is the power connection,
not the headphone jack.
6. Plug the USB cable (see Parts List, item K) into
the tablet and into the transition box.
power
cable port
USB cable
port
back
front
transition box USB
connection to tablet
transition box power
connection to tablet
front