Handicare Exigo 20, User Manual

Page: 16 / 36

16
A
A
A
MB3196-EN
Adjusting the brakes
Figures 28 and 29
The wheelchair is delivered as standard
with brakes which are adjusted to the
middle driving-wheel position.
To move the brakes, undo the screw (28A)
located on the inside of the frame at the
front of the chair. Move the entire brake
assembly along the track to the desired
position. The correct distance between the
brake block and the wheel (29A) is about
2.5 cm.
It should not normally be necessary to
adjust the brakes from the position in which
they are delivered.
Adjusting the anti-tip stabiliser
Figure 30
You should adjust the anti-tip stabiliser
when you have changed the centre of
gravity of the chair.
• Undo the screws (30A). Push or pull the
anti-tip stabiliser to the correct position
• There should be a maximum of 25 mm
from the end of the anti-tip stabiliser to
the floor
• Retighten the screws
Figure 30
Adjusting the wheelchair
Figure 29
Figure 28
Figure 29
Figure 28