ENGLISH
Figure 112
Figure 113
HANDICARE 2000 SIMPLICITY / STYLE INSTALLATION MANUAL
35
Remote control handsets
Note:
If the red button on the control board is
depressed for more than 10 seconds then the
handset will not be programmed. You must
repeat the programming again.
b
For multiple lift applications:
i
Remove the red dipswitch protection
cap with a small screwdriver
(Figure 109)
.
ii
Set the dipswitches on the PCB on both
handsets to the same settings – note
that the next pair of handsets will require
the dipswitches to be set to a different
combination
(Figure 113)
.
iii
Press and hold the red button on the
PCB
(Figure 112)
– a yellow LED will
illuminate on the PCB.
iv
Press any button on one handset and
the yellow light will go out.
v
Programming is complete.
3
Test that the handsets have programmed
correctly by pressing the up and down button
on each and check that the lift moves in the
corresponding direction.
4
Finally fit the power unit front cover.
