14 |
www.HandiQuilter.com
Â
IMPORTANT
: The connector is keyed to ensure correct alignment. Make sure the keyed portion of
the cable connector aligns with the keyed portion of the encoder connector. Do not force.
Power Cord
To install the power cord
•
Insert the cord into the power connector on the rear of the machine. Secure the cord with the
metal clip. Plug the three-prong end into power source. Do not turn on the machine until the front
handlebars and display are installed.
To disconnect the power cord
•
Unplug the cord from the power outlet. Relese the metal clip where the cord connects with the
machine and then pull out the cord.
For more information, see
Power Switch
in the
Using Your Machine
section of this manual.
NOTE
: Make sure that the machine is off before plugging into power source. The rear power switch
should be in the 0, or off, position.
Handlebars and Display
U
CAUTION
: To prevent any electrical damage to the handlebars, always turn off all power to the
machine when connecting or disconnecting the handlebars.
To install the handlebars
ONLINE
: For more information about installing the handlebars, watch the video
Installing the
Front Handlebars
at:
http://www.handiquilter.com/videos/SimplySixteen
103
.
1.
Ensure that the machine is unplugged from the electrical outlet.
2.
Locate the three long button head screws and
the 4 mm Hex tool. Line up the holes on top of
the handles with the pre-drilled holes on top of
the machine.
3. Slide a single screw into one of the holes until
it stops. Hand tighten the bolt enough to secure
the handles to the top of the machine. Insert
and hand-tighten the remaining two
handlebar bolts.
4.
Use the included 4 mm Hex tool to securely
fasten the handles to the front of the machine.
