20
* Use only left twist thread.
z
Raise the presser foot lifter. Press the Up/Down
needle button twice to raise the needle to its
highest position. Turn the power switch off.
Set a spool of thread on the spool pin.
Pass the thread through the guide on the thread
guide bar
q
from the behind.
x
Pass the thread through the thread guide plate
w
, then draw the thread between the pre-tenison
disks
e
under the pre-tension dial
r
.
* If the thread flutters around while sewing,
pass the thread through three holes in the
guide plate as illustrated in fig.(A).
* The standard setting of the pre-tension dial is
that the screw head
t
sinks about 4 mm (1/8
˝
to 3/16
˝
)
y
.
c
Holding the thread with both hands, draw the
thread down and around the tension dial
u
from
right to left.
Pull the thread up to insert it between the tension
disks
o
and pass it over the tail of the check
spring. Then pull the thread down over the loop of
the check spring
i
.
v
Draw the thread through the thread guide
!0
,
!1
and eye of the thread take-up lever
!2
.
Pass the thread through the thread guide
!1
again. Holding the thread with both hands, slip the
thread into the thread guide
!3
as shown.
b
Draw the thread down to the needle bar thread
guide
!4
, then pass the thread through the
needle
!5
.
Use the built-in needle threader (see page 22).
Threading the Needle Thread
c
!0
!1
!2
!3
o
u
u
i
i
x
y
t
b
v
u
!0
!1
!3
!4
!5
w
e
r
!2
(A)
x
z
q
!4
!5
* Utilice sólo hilo con torsión a la izquierda.
* Utilisez uniquement du fil à torsion gauche.
