02/10/2015
www.HandiQuilter.com
HQ Fusion User Manual | 17
Slide the thread through the slot and under
the tension spring leaving five to six inches
of thread hanging loose
Do not lift the lever on bobbin case. Fit the
bobbin case onto the hook spindle in the
machine. Rotate the casing until the open
throat keys into the alignment notch in the
middle of the hook. Push the casing in until
it stops in place. Push inward until it clicks.
NOTE
: Do not use the lever on the bobbin case for this installation. Use the latch lever only for
removal of the bobbin case.
U
CAUTION
: Turn off the power switch while inserting the bobbin case or anytime the hands are
near the needle area.
To bring the bobbin thread to the top of the quilt
1.
After the machine is threaded, locate needle up/needle down button on the left handle.
2.
While firmly holding the tail of the needle thread, press the needle up/down button with your free
hand to bring the needle back to the up position.
3.
Move the machine three to four inches while holding the needle thread. The bobbin thread will
pull to the top.
4.
Grasp the loop formed by the bobbin thread and pull it to the desired length.
Bobbin Tension
The bobbin tension is the foundation tension for the entire machine.
Tension
Spring
