![background image](http://html1.mh-extra.com/html/hand-held-products/4600g/4600g_user-manual_589684023.webp)
4600rp, 4600g/4600r, 4800i User’s Guide
1 - 7
Connecting the Imager with RS-232 Wedge
Note: See
"Imager Models"
on page 1-2 to determine which interfaces apply to
your imager.
Your imager uses True and TTL signal levels to wedge into an RS-232 serial
network. Use only serial wedge cables to prevent damage to the imager. Refer
to
RS-232 Baud Rate
on page 2-10 to set the baud rate and communications
protocol.
1. Turn off power to the computer.
2. Disconnect the existing serial cable from the computer.
3. Connect the appropriate interface cable to the imager.
Note: For the imager to work properly, you must have the correct cable for your
type of computer.
4. Plug the serial connector into the serial port on your computer. Tighten the
two screws to secure the connector to the port.
5. Plug the other serial connector into the host connection and tighten the two
screws.
6. Plug the power pack cable into the receptor on the imager cable.
7. Plug the power pack into a power source.
8. Once the imager has been fully connected, power up the computer.
Host
Termin
a
l
Summary of Contents for 4600g
