HOME-ESS-HV-5.3K
Empowering Energy Clean And Affordable
21
4.3 Installation
Make sure the ground is level and strong enough to bear the weight of products.
Before you start connecting cables, make sure that the inverter and battery are entirely switched off!
Make sure there is no water source above or near the battery, including downspouts, sprinklers, or
faucets.
The altitude to install the equipment shall be lower than the maximum working altitude 2000m.
Install the equipment away from electromagnetic interference. If there is any radio or wireless
communication device below 30MHz near the equipment, make sure that the equipment is at least 30m
far away from the wireless device.
Step 1: Locate drill holes in the wall
Locating drill holes in the wall using the bracket 2(the longer) as a template with a level, position the holes
on the wall, mark the positions of the 3 holes, and then drill 10mm holes to ensure that the depth of the holes
exceeds 50mm. The bracket 2 should be placed (100+162*N)mm above the ground, (N=the number of the
battery module).
Figure 13 Sample of Step 1
Step 2: Fix the anti tipping bracket 2
Fit the expansion tubes into the holes, pull them tight, and then use the expansion screws (packaged with
expansion tube for use) to install and secure the wall mount bracket to the wall.
Figure 14 Sample of Step 2
