HANBAY Inc
User Manual RDx-B-xxxDT-10.31 Battery Fail Safe
Page 2 of 8
www.hanbayinc.com
Rev. 1 2019
1 800 315 4461
Wiring:
Wiring schematic for RDx-B-xxxDx-10.31:
Terminal # DC Power Supply only
6->
+24VDC
5->
Power Gnd
4 ->
Output TTL2
3->
Output TTL1
2->
Input TTL2
1->
Input TTL1
P1 Terminal pin out (standard)
Connect the power:
The
RDx-B-xxxDT
must be connected to 24vDC (to allow the batteries to
charge).
The power consumption will range from max. 3.0A to approx. min. 100mA
when the actuator is active. When not moving, the actuator draws less
than 30mA if the batteries are fully charged.
Locate the correct connection
terminals as shown in the picture to
the left then connect according to
the connection schematics above.
Do not remove or change the
existing
BLACK
or
RED
wires that
connect the battery board to the
processor board.
P1 Terminal
6 5 4 3 2 1
For R-series non explosion rated.
B4 B3 B2 B1
Battery Board
Terminal
