EN
46
• Check the battery clamps regularly to see whether they have come loose, rusted or been
affected by defects or leakage� Maintenance may be necessary�
• Protect the battery, the washer and the power supply components from
high temperatures, and keep them away from flammable/explosive materials�
• The risk of electric shocks can be reduced by using insulated tools or gloves when carrying
out repairs or maintenance�
• Contact the manufacturer or the distributor if the battery is faulty� Do not dismantle
the battery yourself�
• Do not clean the battery with organic solvents as this may damage the battery�
SToRAGE
• The portable washer is sensitive to cold� The washer should consequently not be stored outdoors
or in other places where the temperature can fall below 0°C (32°F)�
• If the temperature falls below the freezing point, the washer can be extensively damaged,
invalidating the warranty�
• Before storing the washer it must be turned off according to the instructions�
EmpTyING oF WATER
1�
Turn off the switch and press the trigger on the spray nozzle to reduce the pressure� Remove
the spray nozzle and press the trigger to empty out all the water� Empty the water container�
Start the washer and run it for about 30 seconds without the spray nozzle�
2�
Remove the hose� Lift up one end of the hose so that the water runs out�
3�
Remove and place hose, spray nozzle and power cable in the storage pocket�
4�
If the washer has to be stored in a place where there is a risk of the temperature falling below
0 degrees, or if it is stored for more than 30 days, a pump rust protector or non-toxic anti-
freeze for cars can be used to counteract frost and reduce the amount of mineral deposits�
ANTI-FREEZE
WARNING
Only use anti-freeze for cars� Other types of anti-freeze can cause rust which will damage
the pump and invalidate the warranty�
Refilling with anti-freeze
1�
Pour about 3 litres of anti-freeze into the water container�
2�
Connect the hose, spray nozzle and power cable�
3�
Start the washer and press the trigger until an even flow of anti-freeze
sprays out of the spray nozzle�
4�
Turn off the washer� Press the trigger to reduce the pressure�
5�
Remove and place hose, spray nozzle and power cable in the storage pocket�