EN
44
Filling with water
Always do as follows after you have filled the water container:
1�
Fill the container with water�
2�
Connect the hose to the washer�
3�
Connect the power cable to the washer�
– If the cigarette lighter socket is used: Connect to the cigarette lighter socket or
the power plug� Move the switch to ”II”�
– For battery operation: Fit the battery and move the switch to ”I”�
4�
Point the hose (without spray nozzle) into the water container�
5�
Start the washer and use it for about 30 seconds or until there is an even
jet of water�
6�
Turn off the washer�
7�
Insert the spray nozzle in the hose�
SToppING
Automatic shutdown function
• When the trigger is released the pressure rises, which means that the washer’s motor turns off
automatically�
• When the trigger is pressed in the pressure falls, which activates the motor so that the pressure
rises again (with some delay)�
• For this function to work, more than 5-10 seconds have to pass between when the trigger is
released and pressed in�
Turning off
1�
Move the switch to the OFF position�
2�
Press the trigger on the spray nozzle to release any remaining water in the hose and
the spray nozzle�
3�
Disconnect the hose from the washer�
4�
Disconnect the spray nozzle from the hose�
5�
Press the trigger to remove the last of the water from the spray nozzle�
mAINTENANCE
WARNING
Always disconnect the power plug before maintenance begins�
CLEANING SpRAy NoZZLE
If the spray nozzle is clogged the pressure in the washer becomes too high, which leads to
overloading�