FLAME CHARACTERISTIC
,
n the
is serviced
and or repaired.
OPERATION PRESSURE CHECKED:
RE-LIGHT:
1) Turn the control knob to "OFF " position.
3) Repeat steps beginning with step 3 of the lighting instruction.
SHUT DOWN INSTRUCTIONS:
1) Push in and turn control knob clockwise to "OFF" position.
2) Turn LP cylinder valve to "OFF" position.
THE EVENT OF GAS LEAKAGE:
Turn the control knob to "OFF" position.
Turn LP cylinder valve to "OFF" position
Wait 5 minutes to allow gas to dissipate.
If odor continues, immediately call gas supplier.
WARNING :
Heater will be hot after use. Handle with extreme care.
0
1
M
O
C
.
Y
A
B
N
O
T
P
M
A
H
.
e
c
n
a
t
s
i
s
s
a
r
e
h
t
r
u
f
r
o
f
N
O
T
P
M
A
H
-
D
H
-
5
5
8
t
c
a
t
n
o
c
e
s
a
e
l
P
Operation
LIGHTING INSTRUCTION
1. Turn the control knob to “OFF” position.
2. Turn LP cylinder gas valve to fully open position.
3. Push in gas control knob and turn counter-clockwise to "PILOT" position, at the
same time push in the ignition button and keep the button depressing until
light the pilot.
4. Once the pilot is lit, continue to keep the control knob depressed for at least 30
seconds, Then release control knob.
5. If pilot does not stay lit, repeat steps 3 and 4 after 5 minutes.
6. If pilot still does not stay lit, then:
a) Push in gas control knob and turn counter clockwise to the "PILOT" position.
b) keep depressing the control knob, put long stem lighter into the ignition hole
on the emitter screen to light the pilot.
c) Repeat step 4.
7. Push in and turn control knob counter clockwise to "HIGH" position, If you want
a lower temperature, push in the control knob and turn clockwise to the "LOW" position.
