9
HAMPTONBAY.COM
Please contact 855-HD-HAMPTON for further assistance.
Assembly (continued)
9
Tightening bolts and placing the tiles
□
After making any necessary adjustments to the parts,
use the hex wrench (CC) to tighten all bolts (AA and BB).
Tighten each bolt a few revolutions at a time. Repeat until
all bolts are tight. Do not over tighten. Over tightening
may strip bolts. Cover all bolts with covers (DD). See the
illustrations in steps 1 - 8 for proper placement of the bolt
covers (DD).
□
Note the clear bumpers spaced evenly throughout the
inside of the table top. Carefully place tiles (R) inside the
table top, resting on the clear bumpers.
10
Placing the lava rocks
□
Pour the lava rocks (J) into the burner. Completely cover
the burner.
□
Remove the cardboard cover (1) from the ignition well.
11
Testing for leaks
□
Open the tank valve. Apply a solution of soapy water
to the tank-regulator connection and to the valve-hose
connection to check for leaks. If soap bubbles continue to
form, the connection has a leak. If a leak is found, close the
tank valve and tighten all connections.
WARNING:
12
Installing the battery
□
Make sure the control knob is in the "OFF" position.
Unscrew the push button cap on the ignition module
located on the control panel to access the battery
compartment. The ignition module requires one Alkaline
WARNING:
Dispose of battery safely. May explode or leak
IGNITOR
( 1.5V )
AAA BATTERY
COMARTMENT
INSTALL (-) SIDE
FIRST
R
J
1
