8
Installation (continued)
5
NOTE
:
Your fan blades are reversible. Select the blade side
finish which best accentuates your decor. Failure to follow
below procedure could result in fan wobble.
The fan blade assemblies are to be attached to the motor using the blade
holder screws (1) that are pre-installed into the blade holder (D). The
procedure to attach blade assemblies is as follows:
Figure 12
Position the blade holder (D) above the motor such that the
pre-installed screws on the blade holder fits into the holes in
the motor (Figure 13). Tighten the pre-installed blade holder
screws (1).
2
Repeat these steps to install the remaining
blade
assemblies
.
Figure 13
Attaching the fan blades
Mount the blade holders (D) to the fan blades (E) using the
square neck screws (AA), hex nuts (CC) and flat washers (DD)
provided - 3 each per blade (Figure 12).
When the electrical connections have been
made
,
take the fan off the hook
.
Slide the ceiling
canopy up the downrod
,
making sure that the
ball joint groove engages with the ceiling canopy
entry
hole
tab
.
Slide
the
bayonet
slots
on
the
ceiling canopy onto the screws at either end of
the mounting plate
,
secure with the four screws
provided (Figure 11).
Figure 11
Finishing the installation
Downrod
Ceiling
Canopy
Bayonet
Locating Slot
Screw
Hole
Mounting
Plate
Groove
Ta
b
1
6
RDB9144-WH/BN/ORB
CC
DD
D
AA
E
