9
Figure 18
Bulbs
Glass
Shade
Light Kit
Assembly
3
1
2
L
Remove the 1 of 3 screws from the light kit
mounting plate and loosen the other 2 screws.
(Do not remove)
While holding the light kit assembly under
your fan, snap the wire connection plugs
together. (Fig. 17)
Carefully push all wires back into the light kit
mounting plate. Place the key holes on the
light kit assembly over the 2 screws previously
loosened from the mounting plate, turn the
light kit assembly until it locks in place at the
narrow section of the key holes. Secure by
tightening the 2 screws previously loosened
and the one previously removed. (Fig. 17)
1.
2.
3.
Install 1 x 75 watts halogen bulb (included)
into the light sockets.
Raise glass shade up against light kit and
secure it to fan by twisting glass clockwise
until snug.
Do not overtighten
. (Fig. 18)
Restore power and your light kit is ready for
operation.
4.
5.
6.
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
Screws
Light Kit
Assembly
Wire Connection
Plugs
Installing the Light Kit
Light Kit
Mounting Plate
Figure 17
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
ATTENTION
FAN INCLUDES A 190W LIMITER TO COMPLY
WITH THE DEPARTMENT OF ENERGY 2009
REGULATION. LAMPING THIS PRODUCT OVER
190W WILL CAUSE THIS FAN TO NOT LIGHT.
PLEASE USE BULBS WITH A TOTAL WATTAGE
UNDER THE 190W REGULATION.
3
1
2
L
Summary of Contents for Northport 178-047
Page 2: ...Northport by Hampton Bay ...
