10
Installation - Existing Construction(continued)
6
Install the air outlet and fan motor part
From the attic side, install the duct connector to the housing
by aligning with the tabs to secure in place. Figure 1.
From the room side, place the fan motor into the housing in
the ceiling. Figure 2.
Secure the fan motor in place to the screw holes in side the
housing. Figure 3.
7
Install wiring cover
Replace the wiring cover into the housing and
secure it with a screw.
5
Connecting the house and fan wires.
Remove the nut from the 120 V AC house wire.
Use the quick connector- 3 pin (H) and quick connector -2 pin (I)
to secure the 120V AC house wirings to the fan wires as shown
in the wiring diagram on page 3.
Carefully push the connected wires back into the wiring fan
housing (A).
Reattach the nut from the inside of housing(A) and make sure
wires and terminals in the wiring compartment of the fan
housing (A).
8
Select the airflow
Select desired airflow (80CFM or 110CFM) by sliding
the toggle switch on the bottom of the housing (A).
80 110
Green
Black
White
tighten the screws
tighten the screws
①
③
②
