11
The receiver frequency selectoris located on
the top of the motor assembly plate as show in
Fig. 17.
The transmitter frequency selector is located in
the battery compartment as shown in Fig. 17.
Each frequency selector has 4 switches, you
may use any number of possible combinations
but you must set each switch in the transmitter
to match the same switch in the receiver.
1.
2.
"HI, MED, LOW"
buttons:
These three buttons are used to set the fan
speed as follows:
LOW
=Low speed,
MED
=Medium speed
HI
=High speed
"OFF"
button:
This button turns the fan off.
The " " button turns the light ON or OFF
and also controls the brightness setting. Press
and release the button to turn the light ON or
OFF. Press and hold the button to set the
desired brightness. The light button has an
auto-resume, it will stay at the same brightness
as the last time it was turned off.
1.
2.
3.
Restore power to the ceiling fan and test for
proper operation.
Figure 17
Installing the Battery
Install
12V MN21/A23
battery (included), to
prevent damage to transmitter, remove the battery
if not used for long periods (Figure 18).
Figure 18
Operating Your Transmitter
Figure 19
Frequency Switch
