5
Installing the fan without arrow style
decorative downrod (with 4-1/2"
downrod) (Recommend min. 8.25 ft ceiling
height).
Remove the hanger ball from the 13" downrod
by loosening the set screw at the top of the
downrod which holds the hanger ball to the
downrod.
Slide the hanger ball down the downrod and
remove the support pin.
Reinstall the ball to the 4-1/2" downrod.
Remove the clevis pin, cotter pin and set
screws from the top of the motor assembly.
Route wires exiting from the motor collar
through the collar cover, canopy cover, canopy
and then through the ball/downrod (Fig. 6A).
Follow the steps 5 & 6 in section titled
"Hanging the Fan" for installation.
1.
2.
3.
4.
5.
6.
Figure 6A
Motor Wires
Ball/Downrod
Assembly
Ceiling Canopy
Canopy Bottom
Cover
Pin in Locked
Positioon
Motor Collar
Motor Collar
Cover
Tighten Screw
Firmly
With 4 1/2" Downrod
Pass the 120-volt supply wires through the
center hole in the ceiling mounting bracket as
shown in Figure 7.
Install the ceiling mounting bracket on the
outlet box with the screws and washers
provided with your outlet box (Figure 7).
Security tighten the two mounting screws.
Carefully lift the fan assembly up to the ceiling
mounting bracket and seat the hanger ball in the
mounting bracket socket. Make sure the tab on
the mounting bracket socket is properly seated
in the groove in the hanger ball (Figure 8). This
will help to balance the ceiling fan.
Installing Fan to
the Electrical Box
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR OTHER PERSONAL INJURY. MOUNT
FAN ONLY TO AN OUTLET BOX OR SUPPORTING
SYSTEM MARKED ACCEPTABLE FOR FAN
SUPPORT AND USE THE MOUNTING SCREWS
PROVIDED WITH THE OUTLET BOX.
Cotter Pin
Clevis Pin
1.
2.
3.
4.
Figure 7
UL Listed Outlet Box
Ceiling Mounting
Bracket
120V
Wires
Mounting
Screws
(Supplied
with Electrical Box)
Tab
