Receiver
Hanger bracket
Figure 11
Figure 12
WARNING:
To avoid possible electrical
shock be sure electricity is turned off at the
main fuse or breaker box before wiring.
NOTE:
The Wall Control units included
with your ceiling fan are equipped with 16
code combinations to prevent possible
interference from or to other remote units.
The dip switches on your Receiver and
Transmitter units have been preset at the
factory, please re-check to make sure the
switches on both units are set to the same
positions. The frequency settings should be
changed only in case of interference or if a
second or more remote controlled ceiling
fans are installed in the same structure. Any
code combination will operate the ceiling
fan and light as long as the Receiver and
Transmitter units are set to the same codes
(Fig. 11)
Step 1.
Insert Receiver into Hanger Bracket
with the flat side of the Receiver facing the
ceiling. (Fig. 12)
Step 2.
Motor to Receiver Electrical
Connections: Connect the Black wire
from the fan to Black wire marked "TO
MOTOR L". Connect the White wire from
the fan to the White wire marked "TO
MOTOR N" from the receiver. Connect the
Blue wire from the fan to the Blue wire
marked "For Light" from the receiver. Secure
wire connections with the plastic wire nuts
provided. (Fig. 13 and 14)
(Fig. 13 and 14)
connectors
Step 3.
Receiver to House Supply Wires
Electrical Connections: Connect the WHITE
wire (Neutral) from the outlet box to the
WHITE wire marked "AC in N" from the
receiver. Connect the BLACK wire (Hot)
from the outlet box to the BLACK wire
marked "AC in L" from the receiver. Secure
all wire connections with the plastic wire nuts
provided.
Step 4.
If your outlet box has a GROUND
wire (Green or Bare Copper) connect this wire
to the Hanger Ball and Hanger Bracket
Ground wires. If your outlet box does not
have a Ground Wire, then connect the Hanger
Ball and Hanger Bracket Ground Wires
together. Secure wire connection with the
plastic wire nut provided. (Fig. 13 & 14)
After all
are made, check to make
sure there are no loose strands. As an
additional precaution we suggest to secure the
plastic wire connectors to the wires with
electrical tape.
ON
ON
5. Electrical Connections
