RACING-STYLE SEAT BELT (IF EQUIPPED)
To wear the racing-style seat belt properly, do the following:
1. Sit in the seat and place the shoulder belts over your shoulders. Make sure
the belts are not twisted.
2. Take the left latch plate and thread it through the belt plates in the following
order: left shoulder belt, center lap belt, right shoulder belt.
3. Push the latch plate into the buckle on the right lap belt until it locks. Pull on
straps to tighten.
SEAT BELT INSPECTION
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide
smoothly into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage,
including cuts, wear, fraying or stiffness. If any damage is found, or if the seat
belt does not operate properly, have the seat belt system checked and/or
replaced by an authorized dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap
and water. Do not use bleach, dye or household detergents.
SWITCHES
IGNITION SWITCH (LE-MODELS ONLY)
The ignition switch is a three-position, key-operated switch. Use the ignition
switch to start the engine. See the Starting the Engine section for starting
procedures.
The key can be removed from the switch when it is in the OFF position.
OFF
ON
START
The engine is off.
Electrical circuits are
off, except accessory
12V.
Electrical circuits are
on. Electrical equipment
can be used.
Turn the key to the
START position to
engage the electric
starter. The key returns
to the ON position when
released.
25