Hammer N2-35, Operating Manual

Page: 45 / 60

45
!
"
Y
X
Y>X Y<X
Bandsaw
N2-35
Faults
9.4.3 Tiltable table
Fig. 9-6: Tiltable table
1.
Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
2.
Lubricate the guides and gear unit with normal machi-
ne grease. Check if functioning.
!
Guide
"
Gearbox
If the cut, using the longitudinal stop, is still not parallel,
the following are possible causes:
• Incorrect saw belt grinding and set
• Insufficient saw belt tension
• Incorrect longitudinal stop setting in relation to the
saw belt.
Setting the rip fence - See chapter entitled 7.2.4
9.5 Direction of cut and parallelism
Fig. 9-7: Direction of cut and parallelism