Hammer N2-35, Operating Manual

Page: 38 / 60

38
B
A
B
"
! #
!
A
!
$
B
A
!
"
#
Bandsaw
N2-35
Setting the rear guides
Loosen the clamping screw.
Adjust the back guide with the set screw.
Adjust the back guide parallel to the saw band back
with a small distance.
Tighten the clamping screw.
Setting the side guiding elements
direction A
Loosen the clamping screw 1.
Displace the guide part over the guide rod.
The side guides must be positioned behind the main
teeth of the saw blade, and even when cutting, must
not be able to come in contact with the teeth.
Clamp the clamping screw 1.
direction B
Loosen the clamping screw 2.
Slide the lateral guide on the adjusting bolt.
The side guide rollers should touch the saw blade
slightly so as to obtain a straight and vibration-free
cut.
Clamp the clamping screw 2.
!
Clamping screw 1
"
Clamping screw 2
#
Guide piece
$
Sliding link pins
!
Clamping screw
"
back guide
#
setscrew
Fig. 8-9: Setting the side guiding elements
Fig. 8-10: Setting the rear guides
8.5.3 Saw blade guide - down (Option)
Operation
Attention! Risk of material damage!
The saw band guides can only be adjusted after the band tension and band run have been set correctly. The
saw band guides must be readjusted after each saw band change.
Make the following settings precisely to prevent possible ignition sparks.