Hammer N2-35, Operating Manual

Page: 35 / 60

35
!
X
Y
Y
X
X > Y
Y
X
X < Y
#
!
"
$
$
$
#
Bandsaw
N2-35
8.3.1 Setting - Saw blade track / Lower wheel
Attention! Risk of material damage!
The saw band run should only be adjusted with the hand wheel on the upper wheel.
If the belt run cannot be adjusted with the upper wheel, an adjustment must be made on the lower wheel.
Only the vertical adjusting screws for adjusting the lower wheel can be changed.
Proceed very cautiously with the settings described here.
!
setscrew 1(Vertical)
"
setscrew 2(Vertical)
#
Locking nut
$
Pin
Measure the distance Y and X (from the front edge of the
wheel to the machine frame). The values X and Y must be
equal.
Setting - at X>Y:
Loosen the lock nuts.
Turn set screw 2 counterclockwise.
Turn set screw 1 clockwise until the pin is fixed.
Tighten the lock nuts.
Turn the wheels manually and ensure that the saw
belt glides properly around the wheels and does not
collide with any solid machine parts.
If necessary, readjust the upper wheel.
Check the setting and readjust if necessary.
Setting - at X<Y:
Loosen the lock nuts.
Turn set screw 1 counterclockwise.
Turn set screw 2 clockwise until the pin is fixed.
Tighten the lock nuts.
Turn the wheels manually and ensure that the saw
belt glides properly around the wheels and does not
collide with any solid machine parts.
If necessary, readjust the upper wheel.
Check the setting and readjust if necessary.
Operation
Turn set screw 1 counterclockwise.
Fig. 8-4: Setting - Saw blade track/ Lower wheel