Hammer N2-35, User Manual

Page: 27 / 60

27
4 x
!
#
"
"
!
#
#
!
Bandsaw
N2-35
7.2.3 Setting up the work table / Angle adjustment
Disconnect the machine from the mains supply.
Levelling the machine / See chapter entitled 7.2.5
Tension saw blade / See chapter entitled 8.3
Angle adjustment: 90° to saw band run
Loosen the clamping lever.
Tilt the work table until it rests on the stop screw.
Place a 90° angle between the running surface of
the saw band and the working table.
If the 90° in the initial position is not correct, adjust
the stop screw accordingly.
Check the 90° angle once the clamping lever is back
in place.
!
Work table
"
Clamping lever
#
Fence screw
$
90° - Angle
Fasten the worktable to the clamp with screws and
washers.
!
Washers
"
Screw
#
clamp
$
Work bench
Fig. 7-5: 90° to saw band run
Fig. 7-4: Work table
Fig. 7-6: 90° to the saw band back
Setup and installation