© 2018 mPTech. All rights reserved. Hammer Iron 2 - EN
21
6.3 Charging the battery
Charge the battery before the first use. The battery should be charged by the
attached charger or another charger intended for this type of equipment. If in
doubt contact the seller or manufacturer service. Use only chargers and wires
recommended by the manufacturer. Using incompatible chargers or cables can
cause explosion of the battery or damage to your device. When the battery is
near a complete discharge, the notification is displayed on a low battery charge.
To continue use of the device charge the battery. If the battery is completely
discharged the device can not be switched on even when the loading process is
ongoing. Before the device can be turned on again, the battery has to be charged
for at least a few minutes. In case of any problems with the battery or if in need
of a replacement, the device should be delivered to the manufacturer's service
center. To charge the battery, connect the microUSB plug to the socket in the
device and the USB plug to the charger.
Incorrect charger connection (USB cable) can cause damage to the AC adapter or
the device. The damages resulting from improper handling are not covered by the
warranty.
Plug the charger into the wall socket. Once you start charging, an icon of the
battery situated in the upper right corner will change to an animated symbol of
lightning. If the device is turned off an animation depicting the level of battery
charge should appear.
The device can heat up during charging. It is a regular occurrence and should not
affect the stability or performance of the device.
When the charge reaches 100% it means that the battery is fully charged. Finish
the charging.
Unplug the charger from the from the wall socket and from the smart phone.
If the phone does not charge properly deliver it (with the charger) to a service
center of the manufacturer.
