Hammer A3-26, User Manual

Page: 49 / 72

49


"
!
Planer-Thicknesser
A3-26 / A3-31 / A3-41
Note: For easy handling, use the table extensions
(See assembly instructions „Table extension“).
Fig. 9-19: Working two workpieces
Note: A maximum of 2 workpieces may be worked simultaneously. The thickness of the workpieces may
not differ by more than 1 mm. The workpieces must each be inserted at the end of the feed roller.
Fig. 9-18: Working a single workpiece
When working, adopt the working position displayed in
the diagram opposite.
1.
Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
2.
If required, retool from surface planing to thickness
planing.
3.
Extraction system must be connected
4.
Every time the machine is put into operation, test the
kickback guards to ensure that they are functioning
properly.
5.
Adjust the thicknessing height.
Use the system handwheel to set the desired measu-
rement.
Clamp the clamping lever.
6.
Switch the machine on
7.
Lift and then release the gear lever
8.
Take up work position.
9. Machining the workpiece:
• Push the workpiece into the machine until it is pulled
in by the feed rollers.
• When the workpiece exits on the other side,
support it so it does not tip down
10.
If you are not going to continue working, switch off
the machine and secure it against being turned on
again accidentally
11.
Set the gear lever to the “0” setting.
!
Clamping lever
"
Gear lever
Fig. 9-17: Working position
9.5.3 Work place/work position
Operation