42
"
!
"
!
Planer-Thicknesser
A3-26 / A3-31 / A3-41
9.3 Switching off the machine / EMERGENCY-STOP
Note: It is only permitted to switch on the machine if, for the work at hand, the required preconditions are
fulfilled and any preliminary work is completed. Therefore, the adjusting, fitting and operating instructions
(see the corresponding chapters) must be read before switching on the machine.
9.2 Switching on the machine
Attention! Risk of material damage!
Improper operation may cause damage to the machine.
Do not activate the green push button whilst the machine is in operation!
Fig. 9-1: Switching on the machine
1.
Connect the machine to the main power supply.
2.
If available: unlock the main switch and switch on
(position “I”).
3. Only with alternating current:
•
Press the green button on the control panel and
hold it pressed down.
• Release the push button once the machine has
reached the maximum rotational speed.
With a three-phase current motor
•
Press green push button on the control panel and
release.
!
Main switch
"
Green push button - ON
Fig. 9-2: Switching off the machine
1.
Push and release the red push button.
The machine is stopped automatically.
2.
If available: switch off the main switch (position “0”)
and secure.
3.
Disconnect the machine from the main power supply.
!
Red push button - OFF
"
Main switch
Operation
Summary of Contents for A3-26
Page 64: ...64 Planer Thicknesser A3 26 A3 31 A3 41...
Page 65: ...65 Planer Thicknesser A3 26 A3 31 A3 41...
Page 68: ......
Page 69: ......
