Wi-Fi Personal Bridge 150
User Manual
21
4
Connecting your device
This chapter provides basic instructions for connecting the Wireless Gateway to a computer or LAN
and to the Internet.
In addition to configuring the device, you need to configure the Internet properties of your
computer(s). For more details, see the following sections:
•
Configuring Ethernet PCs
This chapter assumes that you have already established a DSL/Cable service with your Internet
service provider (ISP). These instructions provide a basic configuration that should be compatible
with your home or small office network setup. Refer to the subsequent chapters for additional
configuration instructions.
Connecting the Hardware
This section describes how to connect the device to the wall phone port, the power outlet and your
computer(s) or network.
WARNING
Before you begin, turn the power off for all devices.
These
include your computer(s), your LAN hub/switch (if applicable),
and the Wireless Gateway.
The diagram below illustrates the hardware connections. The layout of the ports on your device may
vary from the layout shown. Refer to the steps that follow for specific instructions.
Router Mode (WAN interface is WAN Port through xDSL or Cable modem to Internet):
In this mode, the device acts as a WLAN router for xDSL or cable connection.
