Document #101-0011
12
1/09/07
Error
Code
Error Description
00.
All of the bill accept switches are turned off. Clears when switches are reset.
01.
New Style Money-Bill Magnetics Error. Tokenote-did not find end marker. Clears on next bill.
02.
New/Old Style Money-Visual rejection/total error too high. Tokenote-too many digits on Tokenote.
Clears on next bill.
03.
New/Old Style Money-Visual rejection/individual error too high. Tokenote-unable to store Tokenote.
Too many Tokenotes stored. Clears on next bill.
04.
Tokenote-general rejection. Clears on next bill.
05.
Tokenote-Head 1 and Head 2 pattern different. Clears on next bill.
06.
Tokenote-each head matched a different stored Tokenote. Clears on next bill.
07.
New Bills Only-Too much noise in portrait. Tokenote-unable to store Tokenote. Too many Tokenotes
stored. Clears on next bill.
08.
Bill type found was not acceptable or unknown. Bill accept switch or bill direction switch. Clears on
next bill.
11.
A checksum error was found in the Tokenote EEPROM. Clears on next bill.
32.
The flipper was blocked when the Validator was waiting for a bill to be inserted. Clears in 10
seconds.
60.
At payout time the bill was not blocking the rear flipper. Clears on next bill.
61.
The front or validation sensors were blocked during stack.
86.
A timeout occurred when ejecting the bill. Clears after 10 seconds.
87.
The bill appears to be too long or short. Clears after 30 seconds.
91.
Sidescan error. Clears on next bill.
92
Sidescan error. Clears on next bill.
93.
Seal noise error. Clears on next bill.
94.
Visual bill orientation did not match visual orientation. Clears on next bill.
95
Sidescan error. Clears on next bill.
97.
There was a limited amount of visual variation on the last bill. Clears on next bill.
P .
Tokenote programming mode is entered by turning all DIP switches on. This error will clear when the
switches are reset. Clears when switches are reset.
BILL ACCEPTANCE ERROR CODES
