Document #101-0193
12
11/21/07
V.
Validator Mounting
STA Mounting Instructions
1.
Unplug the power cord or remove all power from the system at the circuit
breaker.
2.
Remove the existing Stacker and Validator.
3.
Remove the Validator bracket from the mounting studs located on the front
wall of the cabinet. Disconnect the heater pad (if present) and remove it as
well.
4.
Secure the new Validator mounting bracket assembly (37-0055B) to the
studs on the front wall of the cabinet using four 1/4-20 nuts.
5.
Secure the adhesive backed foam seal to the inside of the cabinet front
around the Validator opening.
6.
Connect the small end of the 9-pin harness adapter to the STA Validator
and the other end to the system harness.
7.
Slide the Validator into the Validator bracket from the rear.
8.
Connect the Stacker harness and hang the Stacker from the back of the
Validator mounting bracket.