Hamilton Manufacturing Corporation HCS II, Programming Manual

Page: 74 / 80

Document #101-0152 74 1/27/05
APPENDIX A
PDA Flash Card and Battery Installation
1. Main power to PDA should not be plugged in
2. Lay PDA face down and the remove the 4 screws in the back of it. Note: There is a screw in
each corner.
3. Then separate the cover from the cradle (By pulling on the cradle and hanging on to the
cover)
4. Then stand the cradle up with the PDA laying in it.
5. Remove modem from top of PDA and lay off to side.
6. Lay PDA face down.
7. Look for Battery Lock (It is in the center of the back of the PDA)
8. Slide switch from “Lock” to “Main”
9. Slide cover off.
10. Insert main battery into battery compartment. (Battery needs to drop straight in)
11. Replace main battery cover.
12. Slide Lock switch from “Main” over to “Back Up”.
13. Turn PDA over and Battery Back Up cover will fall out
14. Insert battery (back up) into back up compartment. (Battery must slide under the lip of the
opening making sure that the writing on battery is facing up. Battery will not charge if in-
serted incorrectly.)
15. Replace back up battery cover.
16. Slide the Lock switch to the “Lock” position. (Make sure you are in the middle because if
you are not the PDA will not turn on)
17. Plug in main power into outlet.
18. Depress “Power” button on the left side of PDA.
19. Next screen displays: “Initializing Memory”
20. Then screen will display “Starting”
21. Next screen displays: “Welcome”
22. Tap on screen.
23. Next screen displays: “Align Screen” Tap and follow the cross tapping each cross in the