Hamilton Manufacturing Corporation HCS II, Programming Manual

Page: 22 / 80

Document #101-0152 22 1/27/05
Config for Pay-at-the-Pump
•
If you are using a “Pay-at-the-Pump Remote” then select “5” or “6” digit satellite code length
and input the numerical values for your setup. (Make sure you have selected a satellite.)
• By adding more Max Satellites it changes the number of Max Codes allowed per day.
• You are allowed up to 4 Pay-at-the-Pump remotes for either a 5 or 6 digits..
•
NOTE: It is suggested that you set the Max Satellites to four and then only check the Satel-
lites that are used. This will make it easier to add new Satellites without deleting valid codes.
•
Note: If you are using a PAP remote 5 digit satellite code length then your Local code size
(see settings page) must be set to 5 digit.
•
Note: If you are using a PAP remote 6 digit code length then your Local code size ( see
settings page) must be set to 6 digit.
•
Note: The length of the PAP remote satellite code length and Local code size will be deter-
mined by the site controller used with PAP system.