Revision Description:
Request Number:
Issue Code(s):
Updated Information
DOC3934
CS, SP
Revision Date:
07/19/12
Document #:
Approved by:
520007100
DOC3934
Page:
4
of
5
Rev:
B
ENG-FRM-RIC-4.32, Rev. E
Technical Data Sheet
HBH 650
PROPRIETARY RIGHTS NOTICE This document and all information contained within it is the property of Hamilton Beach Brands, Inc. (HBB). It is confidential and
proprietary and has been provided to you for a limited purpose. It must be returned or destroyed upon request. Disclosure, reproduction or use of this document and
any information contained within it, in full or in part, for any purpose is forbidden without the prior written consent of HBB. No photographs may be taken of any article
fabricated or assembled from this document without the prior written consent of HBB.
Figure 2. PC Board. Shown without Mylar Shield.
Motor Removal and Replacement
-
Remove the ground screw securing the green ground wire from the cord.
-
The motor lifts out of the motor shroud once you have removed the wires
attached to the power board and PC board (see
Wiring Detail
above). Note
the wire ties location on the wires coming from the motor. It will need to
be replaced.
-
Remove the screws from the bottom of the machine that secure the
motor shroud.
-
Re-assemble in reverse order and remember to replace wire tie.
Board Removal and Replacement
-
Transfer wires from old board to new board. If wire movement will not allow
transferring the wire, mark the effected wires and connections, remove the wire
connection and replace after the new board is in place.
-
Remove the screws from the bottom of the machine that secure the
motor shroud.
-
Remove the 5 screws that secure the PC board.
-
OR
-
Remove the 3 screws that secure the power board.
-
Re-assemble in reverse order.
