EN - 12
3.1.1. Connecting the Water Discharge
Hose
1.
Pull and take out the end of the hose at the
back of the dryer. Do not use any tools to
take out the hose.
2.
Fit one end of the water discharge hose,
which is provided with the product, to the slot
from which you have removed the hose.
3.
Fix the other end of the water discharge hose
directly to the water outlet or sink
.
CAUITION:
The hose must be
connected in a manner that it cannot be
displaced. If the hose comes out during
water discharge, there might be flooding in
your house.
IMPORTANT:
The water discharge
house must be installed at a height of 80
cm maximum.
IMPORTANT:
The water discharge
hose must not be bent between the outlet
and the product, folded or stepped over.
3.2. Electrical Connection
ATTENTION:
There is risk of fire and
electric shock.
• Your dryer is set to 208-240 V and 60
Hz.
• The mains cable of the dryer is
equipped with a special plug. This
plug must be connected to an earthed
socket protected by a fuse of 16
Amperes as indicated on the type plate.
The fuse current rating of the power
line where the outlet is connected must
also be 16 amperes. Consult a qualified
electrician if you do not have such an
outlet or fuse.
• Our company cannot be held
responsible for damages resulting from
usage without earthing.
2
1
3
IMPORTANT:
Operating your machine
at low voltage values will shorten the
service life and decrease the performance
of your machine.
3.3. Electric Installation
• The clothes dryer installation must be
performed by a qualified installer.
• Install the appliance according to the
manufacturer’s instructions and local codes.
• To reduce the risk of severe injury or
death, follow all installation instruc¬tions.
• If local codes do not permit the 3-wire
power supply cord conenction, only 4-wire
power supply cord must be used.
• Do not use an extension cord.
3.4. Electrical Connection
Before you start, select your receptacle
type.
• If you have 4-wire receptacle, you must
use UL listed NEMA 14-30P 240V / 30A
4-wire supply cord with ring terminals
or spade terminals with upturned ends.
Supply cord must be type SRDT and at
least 5 ft. length.
• If you have 3-wire receptacle, you must
use UL listed NEMA 10-30P 240V / 30A
3 wire supply cord with ring terminals
or spade terminals with upturned ends.
Supply cord must be type SRDT and at
least 5 ft. length.
