Temperature limiter tripped
Set the hot and cold power
switches to
OFF
position.
Wait five minutes, then set
switches to
ON
position.
Wait 30 minutes for water
to heat or cool.
Water is not hot
Dispenser is unplugged
Push plug completely into
outlet
Heating switch not on
Check to be sure heating
switch is turned to
ON
The fuse is blown/circuit
Replace house fuse or reset
breaker
is
tripped
circuit
breaker.
If too many items are
plugged
into
a
single
circuit, move some items
to a different circuit
Temperature limiter tripped
Set the hot and cold power
switches to
OFF
position.
Wait five minutes, then set
switches to
ON
position.
Wait 30 minutes for water
to heat or cool.
PROBLEM
POSSIBLE
CAUSES SOLUTION
No water running
1. empty bottle
1. replace with new bottle
out from faucets
2. inlet of bottle supporter
2. clean out wasted paper
blocked by bottle seal
and bottle seal, install
bottle
again
Water dispenser does
1. empty water bottle
1. replace with new bottle
not work
2. mineral deposits clogging tank
2. see Care and Cleaning.
Water dispenser leaks
crack or pin hole in bottle
replace with new bottle
from the outside
Compressor runs too
1. room temperature is hotter
This may be necessary to
frequently
than normal
maintain a constant
temperature
during
hot
and humid days
2.
dispenser
does
not
have Check
to
be
sure
unit
is
proper clearance
properly located to ensure
adequate airflow
Noisy operation
improper installation
place the machine on level
surface
13
