7
Using Inert Gas
NOTE: Gas tank pressure gauge should not exceed 14.5 psi.
1. Connect inert gas tank to gas nozzle on left side of machine.
2. Program should be set from following above directions.
3. Minor adjustments can be made by adjusting pressure of inert gas from tank. DO NOT EXCEED 14.5 psi.
4. Place pouch opening around gas flush ports and straight across seal bar.
5. Close lid.
NOTE: If no gas is needed and tank is connected to chamber vacuum sealer, then gas time should be
set at “0.0”.
Changing Preset Vacuum and Sealing Times
This unit comes with 10 preset programs that can be customized with user preferences depending on most
frequent usage.
Factory Default for All 10 Programs (P0 to P9)
Vacuum time: 30 seconds. Can be adjusted from 10 to 60 seconds.
Gas flush: 5 seconds. Can be adjusted from 0.0 to 30 seconds.
Seal time: 2 seconds. Can be adjusted from 0.0 to 3.0 seconds.
Soft air: 2 seconds. Can be adjusted from 2.0 to 30 seconds.
Programming and Storing
NOTE: P0 cannot be changed.
1. In standby mode, display will show “ooo” and PROGRAM DISPLAY will show current program number.
2. Press PROG 1-10 button to scroll through programs to find desired program number.
3. Press REPROG button. Program number will flash until desired program is set. VACUUM INDICATOR
will illuminate to show selected vacuum time.
4. Press +/STOP VAC or –/STOP to change vacuum time.
5. Press FUNCTION SELECT . GAS INDICATOR
will illuminate to show selected GAS time.
6. Press +/STOP VAC or –/STOP to change GAS time.
7. Press FUNCTION SELECT . SEAL INDICATOR
will illuminate to show selected SEAL time.
8. Press +/STOP VAC or –/STOP to change SEAL time.
9. Press FUNCTION SELECT . SOFTAIR INDICATOR
will illuminate to show selected SOFTAIR
time.
10. Press +/STOP VAC or –/STOP to change SOFTAIR time.
11. Press REPROG to save parameters.
These are the programmable ranges for each of the four steps:
Name
Time
Vacuuming Time
10–60 seconds
Gas
0.0–30.0 seconds
Sealing Time
0.0–3.0 seconds
Soft Air Time
2.0–30.0 seconds