@X4-0047-5
－ 14 －
5.3.
Operation by the remote (Usage of sample program)
The C9525 power supply can be controlled using the accessory program "C9525_control.exe"
that comes with the C9525.
This accessory program is an executable format file (for Windows) created using Visual BASIC
6.0.
Prepare a PC (personal computer) with Windows 2000 or later version OS installed. Using a PC
that runs on (Windows XP) is recommended.
Connect the C9525 to the PC using the USB cable that comes with the C9525.
To use the accessory program, install it into the PC with the procedure described below.
If Visual BASIC 6.0 is not installed in the PC you are going to use, then install Visual Basic 6.0 SP6
Runtime Library (Microsoft).
The installer pops up by starting "setup.exe". Complete the installation by following the
instructions that appear on the PC screen.
Install the VCP driver (FTDI: Future Technology Devices International Ltd.) for USB control.
1
）
Disconnect the LAN cable (if connected) from the PC.
The driver cannot be installed when the LAN cable is connected. If the PC is
connected to Internet via a dial-up line, disconnect "Control Panel" - "Network
Connection".
2
）
Connect the USB cable to the PC.
3
）
When the Wizard for driver installation starts, specify the folder that contains the driver
to install. The driver should be decompressed in advance since it came compressed.
4
）
A USB serial port is now added to the COM port. Check the number by opening
"Control Panel" - "System" – "Hardware" – "Device Manager".
For detailed information, refer to the OS Installation Guide.
When the accessory program has started while the C9525 power is turned on, the following
screen appears.
