C11440-10C Ver.1.2
7. CONNECTION
7-1 CONNECTING OF CABLES
Refer to the figure when connecting the various cables.
Camera
①
AC adaptor
Computer
②
CameraLink interface
cable (Option)
Figure 7-1
•
When the cables are connected, confirm the power switch of peripheral device is in the OFF position.
①
AC adaptor
This is the cord to supply a power supply. Use the accessory AC adaptor.
②
CameraLink interface cable (Option)
This is the cable to connect the camera and the CameraLink interface board on the computer.
Note
•
Hamamatsu recommends A10514-05 optional CameraLink interface cable for
this camera. The camera complies with EMC direction with using A10514-05
CameraLink interface cable. Be careful that the camera with other interface
cable may not fulfill the EMC directive requirements.
7-2 WHEN THE CAMERA HEAD IS FIXED
The camera head is fixed by using the fitting screw at the bottom of the camera head.
Fix the camera head with a tool such as a laboratory jack so that a load may not be imposed
to the part of C-mount when the camera is fixed by C-mount.
Note
•
Be careful not to allow the fitting screw to enter more than 8 mm from the surface of the mount.
Screwing this in excessively may impair normal operation.
12
