Hama Metallic, Operating Instructions Manual

Page: 3 / 48

3
Note – Capacity
• The capacity is always shown when the Power Pack is charging.
• Each status LED corresponds to 25% of the capacity. When an LED is permanently illuminated, this
indicates that this capacity level has already been reached. The Power Pack is charged to at least
75% if three LEDs are illuminated, and the fourth is flashing.
• If all four status LEDs light up, the full capacity is available.
• Press the button of the Power Pack to switch it on and to check its current capacity.
• To switch the Power Pack off, press and hold the button until the status LEDs go out.
Warnung – Battery
• Only use suitable charging devices or USB connections for charging.
• As a rule, do not charge devices or USB connections that are defective and do not try to repair them
yourself.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging or using batteries in extreme temperatures.
• When stored over a long period of time, batteries should be charged regularly (at least every three
months).
4.2 Charging terminal devices
• Connect the microUSB charging/connecting cable included to the one of the two USB ports on
the Power Pack ( OUT 1 5V/2.1A / OUT 2 5V/2.1A ) and to the microUSB port on your terminal
device (mobile phone, smartphone, etc.).
• The Micro-USB charging/connecting cable included may not be suitable for the USB connection on
your terminal device. In this case, use the USB cable that was included with your terminal device.
• To start charging, press the button of the Power Pack. The status LEDs show the remaining capacity
when the Power Pack is charging.
• The current battery status of your terminal device will appear on this device.
• Press the button of the Power Pack to stop charging and to switch it off. The status LEDs should
switch off.
• The Power Pack will automatically switch off after 10 seconds if it is not connected to a terminal
device.
Warning – Connecting terminal devices
• Before connecting a terminal device, check whether the power output of the charger can
supply sufficient power for the device.
• Ensure that the total power consumption of all connected terminal devices does not exceed
2100 mA.
• We recommend that you always use just one of the two USB ports.
• Please refer to the instructions in the operating manual of your terminal device.
• It is essential that you observe these specifications and the safety instructions regarding the
power supply of your devices.