15
Capture Jet
®
Operation & Maintenance Manual
OM-0
05/0520
17/re
v3/EN
To assemble the KFR filter remover:
Screw together stainless steel pipe, coupling, and bracket and tighten all joints. (as shown in above picture)
KSA Filter Removal with Model KFR
Filter Installation and Removal
16 ga. S.S. Bracket
S.S. Coupling
S.S. Pipe
It is Important that the top lip and
bottom lip of the filter are hooked
correctly
Insert KFR tool
Slide filter up
Push filter back and down
Lift filter out of plenum
Tilt top of filter out
Lift filter into plenum
Push filter in and down
Tilt top of filter in
Lift filter to the front
Slide filter down
Remove KFR tool
To remove filter:
Insert bracket into the inside KSA
filter slots, and lift upward until
filter slides out of plenum.
To install filter:
Place filter on KFR (filter removal
tool) bracket, raise filter into place
inside exhaust plenum. Slide up-
ward until top lip of filter is locked
into place and bottom lip of filter
slides in place inside the exhaust
plenum.
*** It is very Important to lock
top lip of filter in place in instal-
lation as shown in reference
drawing.
