Halstead ACE HE 30, User Instructions

Page: 3 / 4

1
2
LED CODE FAULT/EFFECT REASON
1
Overheated appliance Water temperature greater than 105 °C
2
Differential check faulty/Flame for 15 seconds Zero check faulty DHW or CH
3
No gas or lockout flame signal/Lockout after 5 ignition attempts Low gas pressure. No flame signal on ignition, or loss of signal during operation
4
Flue gas sensor Flue gas temperature greater than 95 °C
5
Defective sensor or thermal fuse Defective flow, return, DHW or flue sensor or open circuit thermal fuse.
6
Defective gas valve/Flame continues after demand ends 5 sec flame signal after burner is switched off
7
Defective fan Missing or Erroneous RPM signal
A
PCB error Internal error
Activate BCC (if fitted) New BCC (if required)
Safety system failure Failure of internal self checking system
E
BCC error (if fitted) Incorrect /missing BCC
O
Water flow failure/Flame for a short period only Sensor temperature differential incorrect
P
Power supply error Low mains voltage
DHW cold Defective DHW thermister or open circuit
(No display) No light indication Defective power supply
NOTE: FAULT CODES 1 TO 4 MAY BE RESET BY FOLLOWING THE PROCEDURE IN SECTION 5.5 OF THE
INSTALLATION MANUAL, HOWEVER IF ANY OTHER FAULT CODE IS SHOWING PLEASE CONTACT YOUR INSTALLER OR
HALSTEAD BOILERS SERVICE HELPLINE TEL: 01926 834834