Installation of the Stability Module (cont’d)
Position of ITCM Stability Module Assembly
If the Stability Module is oriented to the road or curb side of the trailer follow the guidelines
on this page.
The following orientation parameters are required
in the ITCM Stability Module Assembly for correct
operation.
STABILITY MODULE
INSTALLATION/SERVICE
GUIDE (L31288W)
TM
Roll angle : ± 3 ° (1:20)
Yaw angle : ± 5 °
The ITCM Stability Module Assembly must
be mounted within distance X & Y from the
centerline of the rear axle group / bogie
(includes lift axles).
Haldex recommended position for maximum
stability performance. Installation of the ITCM
Stability Module outside of this area may affect
the performance of the unit.
The ITCM Stability Module Assembly must be
installed with the main left hand (LH) and right
hand (RH) chassis members of the vehicle.
For any other installations contact the
Haldex Technical Services Department at
1-800-643-2374, Press #2.
3 º
3 º
3 º
3 º
Within LH & RH
chassis members
X
Y
Rear view
Plan View
5 º
5 º
5 º
5 º
Single or Tri-axle
Within LH & RH
chassis members
Tandem axle
X
Y
Trailer
X
Y
Semi
59” (1.5 m)
59” (1.5 m)
Center Axle
59” (1.5 m)
59” (1.5 m)
Page 8
