Halcyon TRAVELER, Owner'S Manual

Page: 18 / 36

the webbing back through the triglide. Cut off excess webbing “tail” leaving enough for future
length adjustments as necessary (figures 30-31).
Confirm that your hardware is in the correct place by trying on your back-
plate. D-ring should sit appropriately from the bottom of the plate. Sizing
of the quick-adjust crotch strap is now done quickly by sliding the webbing
through the quick- adjust buckle.
Any excess webbing tail may be tucked back through the backplate and se-
cured with a section of the EPDM band off the crotch strap if it’s necessary
to keep it longer, e.g., when using the System in Rental or Training. You will
need to undo this when using the quick-adjust, so be aware of this when
sizing on a new diver.
DOUBLES BOLT EXTENDER
The Cinch can easily be used with double cylinders. If you have shorter bolts
on any set of tank bands, you may need to use the extension bolt on your
bottom tank band. Simply screw the extension bolt to the bottom bolt of the
tank band (snugly) onto the bottom tank band, and set up your backplate as
normal. Note: It is not desirable to use the bolt extender on the top bolt.
INSTALLATION OF HALCYON DELUXE HARNESS PADS
Halcyon offers a Deluxe Harness upgrade featuring a set of shoulder pads and a backplate pad
for the ultimate comfort while diving in thinner exposure suits. Our deluxe shoulder pads allow
the diver to customize D-ring position by way of movable velcro tabs (figure 32-33). The back-
plate pad also features a BC Storage pocket allowing the diver to carry a surface marker or lift
bag in a streamlined position.
To Install Your Shoulder Pads:
Please note that the shoulder pad sits below the harness and is secured by three Velcro tabs
on each shoulder. These tabs can be adjusted up or down to customize their location and make
room for chest D-rings.
Figure 28 Figure 29 Figure 30 Figure 31
18
HALCYON.NET