HDV R 14 1.1
Due to constant technological advancement, the manufacturer may modify the content of this manual without prior notice.
8
4.5
Closing the battery compartment
Stand the propeller protection on a level surface. Carefully check that the lock O-ring (19),
(see fig. 6) is properly seated and that it is clean and suitably greased with silicone oil (the
one commonly used for underwater gear). Check that the rim of the body (20), is clean,
and if necessary pass a clean cloth to remove any dust or sand. Insert the front shell (8)
matching the screw (18) up with the hole (17). Turn the wheel (9) clockwise until it closes
completely and tighten using only two fingers.
Figure 6
5 Correct use
Check the preliminary operations (scooter complete with gaskets and perfectly closed).
Proceed as follows to start the HDV:
Always make sure the switch (6) is in the off position, submerge the HDV under water and
make sure nothing is caught between the propeller blades. If something is found between
the propeller blades, remove the HDV from the water and free the propeller blades of the
foreign object. Be extremely carefully since using hands or other parts of the body
between the propeller blades is potentially hazardous, even if a safety clutch is
installed between the propeller and engine. For this reason, avoid introducing your
hands in the propeller area and, if necessary for cleaning purposes or to remove
foreign objects, use or stick or other suitable tool.
Turn the switch (6) (see fig. 1) to the required speed. The on light, blue led, (25)(see fig.
7) should turn on.
