Slide 36
2.4.5 Settings that can only be carried out with a code or diagnostic connector
Settings that can be carried out by service staff are indicated by having to enter a code in the top field and by the disk
displayed next to the configuration setting for saving.
To avoid having to enter a code, it is also possible to use the diagnostic connector PN 03006790 at connection –
A01.X20 of the control unit.
The code is assigned by the HAKO Service during production at the assembly line or when installing a new control unit.
The code is calculated using the last 4 digits of the 12-digit serial number of the machine plus 1. These are the
positions 9 to 12 of the serial number of the machine.
If no code has been assigned, release for adjusting the configuration can only take place via the service plug.
If parameters are to be changed, the code for setting
parameters must be entered (alternatively, diagnostic
connector).
The lock is unlocked.
If a locked lock is shown next to the configuration
setting, the configuration cannot be changed by
service staff.
If a disk is shown next to the configuration
setting, the configuration can be changed by
service staff. A green number means: the
currently saved content.
The content can be adjusted by turning the turn-push knob, the number then turns white and “OK?”
appears as a prompt for saving the value. After saving, the disk appears and the number turns green.
If saving should not take place, use the “return” key on the keypad to exit the setting.
2.4
Configuration menu
Summary of Contents for Scrubmaster B260 R
Page 64: ...Slide 64 Figure 7 2a Figure 7 2b 7 Mechanical components 7 1 Squeegee...
Page 66: ...Slide 66 Figure 7 4 7 Mechanical components Height adjustment 7 1 Squeegee...
Page 100: ...180 130 170 150 120 Figure 9 5 Slide 100 9 Drive 9 2 4 Steering angle sensor...
Page 121: ...Slide 121 14 Notes...