Haklift Oy
Asessorinkatu 3-7
20780 Kaarina, Finland
Tel. +358 2 511 5511
www.haklift.com
Lifting Solutions Group
Axel Johnson International
(1)
The first green LED will light when the power (3) If the weight limit is exceed, the two red LED’s will
is on to show the product is ready for use. flash and the product will stop pulling.
Release pressure on the load as soon as it is safe to do so.
Do not attempt to move that load again with this product.
Figure B: Product Ready Figure E: Weight limit Exceeded
(first green LED lights)
(two red LED’s flashing)
(2)
As a load is applied, the LED’s will light to
show the level of load
–
the heavier the load,
the more LED’s will light.
(4) If the motor overheats, the fourth yellow LED will light
up and the product will stop pulling. Stop using the product
and allow it to cool for at least 30 minutes before further
use.
Figure C: Low Load
Figure F: Motor Overheated
(fourth yellow LED lights)
Figure D: Maximum Load
Battery
- Always turn off the power when you are not using the product. Do not store the battery at temperatures above
49 degrees celsius.
- If the power of the product deteriorates, charge the battery full. Do not let the battery run out of power
completely, because it will reduce the lifetime of the battery and it may also cause damage.
- If the first green led blinks when the load is applied, charge the battery.
