9
14
Example
：
350 to 400℃
1.Press and hold the button for at least one second.
The hundreds digit will begin to flash.
2. Entering from hundreds to units digit
Press the or to set the desired figure.
Only values from 0 to 5 can be selected when entering the hundreds digit.
(In ℉ mode, values from 1 to 9 can be selected.)
Values from 0 to 9 can be selected when entering the tens or units digits.
(The same values can be selected in ℉ mode.)
When desired figure is displayed, press the button to enter.
The next digit will begin to flash. After entering the units digit, press the button to save
the figure to the system memory and begin heater control with new setting temperature.
Changing temperature setting
The temperature range is from 50 to 500℃. ( 120 to 930℉)
●
If you enter a value outside the temperature setting range, the display returns to the hundreds
digit, and you have to enter a correct value.
Press and hold the button
for at least one second.
If power is switched off or lost during the execution of this procedure, no data will be entered.
The entire procedure must be repeated from step 1.
Press the button once.
■
Password setting
If selecting the Restricted, perform the setting for password.
If selecting the Partial, choose whether or not the password function is needed when changing
the set temperature, the preset number and the offset value and set the password.
Select and input three letters for password from six letters as follows.
Example
：
The procedure for changing the set temperature when the unit is restricted by a password.
(password is AbC)
・
If the password you entered is incorrect, you cannot enter the setting change display.
・
If you enter the password incorrectly twice in a row, the display will return to the previous display.
●
20
：
Ready signal delay time
You can set the delay time after the HAKKO FU-600 gets ready (ie., the temperature of the tip reaches
the set value) until the Iron Ready signal becomes on.
Delay time setting range : 0
〜
60 sec.
The tens digit begins to flash when coming to the delay time entering mode.
Use the method for setting the temperature to enter and set the delay time.
If you enter a value outside the delay time setting range, the display returns to the tens digit,
and you have to enter a correct value.
Press the or button.
Press the or button.
Press the button once.
Press the button once.
The letters for password
CAUTION
CAUTION
CAUTION
Press the button once.
Press the button once.
Press the button once.
Press the button twice.
Press the button once.
Press the button three times.
Press the button once.