●
How to attach the holder part (using C5012 handpiece holder)
Remove the holder part from
the C5012 handpiece holder
(included with the HAKKO FT-
801). Attach the B5247 holder
part (included with the HAKKO
FT-8004). Please use included
SEMS screws for assembly.
●
Removing the blades
Loosen and remove the hexagon socket set
screw fi xing the blades.
As illustrated below,
pull the blade straight out.
●
Attaching the lead adjuster
1. Remove the insulating cover from
the handle cover L-side as shown in
fi gure 1 (side with HAKKO FT-8004
logo) and remove the screw from the
handle cover L-side.
2. Remove the handle cover L.
3. Align the lead adjuster as shown in
fi gure 3 in the designated channel in
the handle cover L. Tighten lightly
in place using mounting bracket and
screw.
4. Firmly fi t the bottom side of the
insulation cover to the handle cover
as shown in fi gure 4.
5. Attach handle cover L to the
handpiece at the bottom and tighten
the screw for handle cover L.
Reattach insulating cover to the top
side of the handle cover L. Adjust the
length of the lead adjuster and fi rmly
tighten the screw.
─ NOTE ─
Pay attention to the direction of the
blades when attaching the lead adjuster.
(See the following fi gure.)
Attach the lead adjuster so that the
adjuster plate end is in parallel with the
blade surface.
The lead adjuster can be removed with
the handle cover attached to the handle.
Holder part
Holder part
(for HAKKO FT-8004)
Lead adjuster
Handle cover L
Insulating cover
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
CAUTION
Please be sure to use the included holder part.
CAUTION
When pulling out or inserting blades, be sure that the power is switched off.
Before pulling out the blades, check that the blades have cooled down suffi ciently.
Hexagon wrench
Hexagon socket set screw
(M2.5×2.5)
V-groove
●
Installing the blades
1. Insert the blades fully and match the
V-groove on the blades to the V-groove
on the mounting fl ange. Push until
blades are fl ush with mounting fl ange.
2. Insert the hexagon socket set screws but do
not tighten.
─ NOTE ─
Blades will not heat up unless both blades are
fully inserted. Be sure to use the blades as a set.
3. Adjust and align the blades manually then
tighten the hexagon socket set screws with
the hexagon wrench to secure the blades.
